SEBO Carrying Handle for 30...
$26.00
Product details
Lifting a commercial upright up a flight of stairs puts the entire weight of the machine through one molded grip. Part 50143GSER is that grip, finished in gray black for the SEBO 300 Mechanical and 350 Mechanical.
Cracks tend to start at the mounting bosses, where the load concentrates and the plastic is thinnest, then travel across the span until the handle lets go. A handle that has begun to flex noticeably under weight is worth changing before that happens, since the failure comes without warning and usually in a stairwell. The replacement picks up the original fixing points, so the swap needs a screwdriver and a few minutes rather than a strip-down of the machine. Check the bosses on the housing while the old handle is off, and clean out any grit that has packed into the seats.
- Part number: 50143GSER
- Fits: SEBO 300 Mechanical and SEBO 350 Mechanical
- Finish: gray black
- Job: lifting point for carrying and stowing the machine
- When to change it: visible splits, flexing under load, a loose mount
- Fitting: reuses the original mounting points, screwdriver only
The second lifting point on these uprights is recessed grip 50130HG in light gray, and the two are worth inspecting together because they fail for the same reason. Up at the top of the machine, the complete handle is listed as 50214HGER, the handle tube with its cover as 50145SE, and the cable hook with screw, washer and spring as 50220HGER. Locking latch 50221HGER covers the other part that gets handled every time the vacuum is picked up or stowed.
Genuine SEBO part, supplied by an authorized dealer. Check the model on the data plate before ordering. Ships in 2-5 business days.